A. Processes
1. Congelifraction (frost weathering) ⭐⭐⭐
- From Latin congelare (to freeze) and frangere (to break).
- Water in joints and pores freezes at night and thaws by day (and over seasons). Ice takes about 9% more volume, so repeated freezing wedges rock apart.
- Most effective where there are many freeze–thaw cycles and a steady water supply, i.e. in the active layer and on exposed rock faces.
- Products: sharp, angular blocks; scree (talus); block fields; tors.
- Some researchers doubt how strong pure freeze–thaw is, and stress ice segregation (growth of ice lenses by water drawn towards the freezing front) as the main rock-splitting mechanism. Either way, frost action is the main cause of rock breakdown in periglacial areas.
2. Frost heave ⭐⭐⭐
- The ground surface rises when water in the soil freezes and ice lenses grow, and sinks back when they melt.
- Fine (frost-susceptible) soils like silt are most affected, because they draw water up by capillarity to feed growing ice lenses (ice segregation).
- Two kinds:
- Vertical heave: stones are pushed upward each winter and do not fully settle back, so stones appear to "grow" out of the ground. This sorts coarse from fine material and makes patterned ground.
- Lateral thrust: in early winter, the active layer freezes from the top down and from the permafrost upward. The unfrozen layer trapped between them is squeezed, which pushes the surface up and contorts the layers (involutions).
- Small ice needles that grow at the surface on cold nights and lift soil grains are called needle ice (pipkrake).
3. Congelifluction (solifluction, gelifluction) ⭐⭐⭐
- Solifluction (Latin solum = soil, fluere = to flow) was named by J.G. Andersson (1906) for the slow downslope flow of water-saturated debris. Gelifluction or congelifluction means solifluction over frozen ground (the periglacial kind).
- Mechanism: in spring and early summer the active layer thaws from the top; meltwater cannot drain into the frozen ground below, so the soil becomes saturated, loses strength and flows slowly downhill even on slopes of only 2–3°.
- Rate: very slow, usually a few cm up to a few tens of cm a year.
- Most active in the transition seasons (spring and autumn), when freeze–thaw is frequent; it stops in late summer (dry) and in winter (frozen).
- Results: solifluction lobes and terraces (stone-banked or turf-banked), stone streams, sheets of debris (head in England). It also smooths slopes and fills valley floors, helping cryoplanation.
Solifluction vs soil creep: creep is very slow movement of soil in any climate; solifluction is flow of saturated soil, and in the periglacial form it moves over frozen ground.
4. Nivation ⭐⭐
- Erosion under and around snow patches: freeze–thaw weathering at the edges and base of the snow, meltwater washing away the fine debris, and some solifluction. Term by F.E. Matthes (1900).
- Produces nivation hollows; a deepening nivation hollow can turn into a cirque if a glacier forms in it.
5. Running water ⭐
- Streams are frozen in winter and overloaded with solifluction debris in summer, so they usually cannot erode much and tend to aggrade (braided channels).
- But spring snowmelt floods can be powerful and cut gullies and ravines.
- Asymmetrical valleys are common: one side is steeper because slopes facing the sun thaw more often and lose more material by solifluction, which pushes the stream against the opposite side.
6. Wind ⭐
- Dry, fine, frost-shattered material and sparse vegetation let wind work in the later stages: ventifacts, grooved rock, periglacial loess (central Europe, Mississippi valley) and dunes.
B. Landforms
Pingos ⭐⭐⭐
- Dome-shaped hills with a core of ice, found only in permafrost areas. The word is from Inuvialuktun, meaning a conical hill; it was introduced into science by A.E. Porsild (1938).
- Size: about 3–70 m high and 30 m to several hundred metres across. Tallest examples: Kadleroshilik Pingo (Alaska, about 54 m) and Ibyuk Pingo (Tuktoyaktuk, Canada, the tallest in Canada).
- There are more than 11,000 pingos on Earth; the greatest concentration (about 1,350) is on the Tuktoyaktuk Peninsula, Mackenzie Delta, Canada.
- Two types, distinguished by the source of water (not by whether the top is open):
ㅤ | Closed-system (hydrostatic) pingo | Open-system (hydraulic) pingo |
Also called | Mackenzie type | East Greenland type |
Permafrost | Continuous | Discontinuous or thin |
Setting | Drained lake beds on flat lowlands | Valley floors and the foot of slopes |
Water source | Water trapped in the unfrozen sediment (talik) under a former lake; as permafrost closes in from all sides, the water is pressurised and pushed up, then freezes into an ice core | Groundwater flowing from higher ground under artesian pressure, through gaps in the permafrost, freezes near the surface |
Main researcher | J.R. Mackay (Tuktoyaktuk, from the 1960s) | Studied in East Greenland and Alaska |
- Mackay showed that most pingos do not form by ordinary frost heave of fine soil, because they are often made of sand too coarse for ice segregation. Closed-system pingos form by pore-water expulsion as permafrost grows into a drained lake bed.
- As pingos grow, the top stretches and cracks (dilation cracks). If the ice core is exposed and melts, the pingo collapses into a ring-shaped rampart with a central pond (pingo remnant or crater).
Palsas and hummocks ⭐⭐
- Palsas: mounds of peat with a core of frozen peat and ice lenses, formed by ice segregation in bogs of the discontinuous permafrost zone (Scandinavia, Finland). Usually up to about 10 m high and 10–50 m across. Unlike pingos, their core is mainly frozen peat with ice layers, not a single ice body.
- Hummocks: small mounds (usually under 1 m) formed by frost heave and cryoturbation; earth hummocks (bare) and turf hummocks (with vegetation).
Patterned ground ⭐⭐⭐
- Regular geometric patterns of stones and fine soil on the ground surface, which look as if arranged by people. Formed mainly by frost heave and sorting, helped by solifluction on slopes.
- Classified by A.L. Washburn (1956) by shape and by whether the material is sorted (coarse stones at the borders, fine soil in the centre) or unsorted.
Ground slope | Pattern |
Flat, less than about 6° | Stone circles, stone polygons, stone nets |
Moderate, about 6–30° | Stone garlands (lobes, stretched downslope), elongated nets |
Steeper | Stone stripes (parallel lines downslope) |
Memory tip: As the slope steepens, circles and polygons are stretched into garlands, then pulled into stripes.
Ice-wedge polygons ⭐⭐
- In very cold winters, frozen ground contracts and cracks into polygons (like dried mud). In spring, meltwater fills the cracks and freezes. Year after year, the ice grows into vertical, wedge-shaped bodies (ice wedges).
- Seen from above: a network of polygons, typically 10–30 m across. When the ice later melts, the wedge is filled by sediment, leaving an ice-wedge cast, used as evidence of past permafrost.
Involutions ⭐
- Contorted, folded layers of loose sediment just below the surface, made by cryoturbation and lateral pressure during freezing. Types: fold, pillar and amorphous involutions.
Thermokarst ⭐⭐⭐
- Irregular, hummocky land with hollows and lakes formed when ground ice melts and the surface collapses.
- Looks like karst but forms differently:
Karst | Thermokarst |
Chemical: solution of limestone | Thermal: melting of ground ice |
Controlled by rock type (lithology) | Controlled by temperature |
Sinkholes, dolines, caves | Thaw lakes, thaw sinks, alas (large subsidence basins in Yakutia), thaw slumps |
- Causes of thaw: climate warming; removal of vegetation; ploughing; buildings, roads and pipelines that warm the ground.
- Example: the Batagaika crater (Yakutia, Siberia), a giant, still-growing thaw slump.
Block fields (felsenmeer), talus and stone streams ⭐⭐
- Block fields (German Felsenmeer, "sea of rocks"): flat or gently sloping hilltops covered with large angular blocks broken off by frost shattering.
- Talus (scree): sheets or cones of angular debris at the foot of cliffs.
- Stone streams (block streams, rock rivers): long tongues of boulders filling valley floors, moving slowly downslope by gravity, frost heave and solifluction. Coarse blocks lie on top; finer material below.
Rock glaciers ⭐⭐
- Tongue-shaped masses of angular rock debris with ice between the blocks or an ice core, which creep slowly downslope (about 0.1–1 m a year), looking like a glacier made of stones.
- They are common in high mountains, including the Himalaya and Ladakh, and are important stores of water.
Tors ⭐⭐
- Piles of exposed, jointed bedrock blocks standing up from a gentle hilltop or slope, often with a spread of fallen blocks (clitter) around them. Common on granite (e.g. Dartmoor, England).
- Theories of origin:
Theory | Proponent | Idea |
Two-stage (deep weathering) | D.L. Linton (1955) | Deep chemical weathering in a warm climate rots the rock along joints; later erosion strips the rotten material and leaves the solid core stones standing |
Periglacial (one-stage) | J. Palmer and R.A. Nielson (1962) | Frost shattering along joints and removal of debris by solifluction under Pleistocene periglacial conditions |
Pediplanation | L.C. King | Tors are residual hills left by parallel slope retreat |
- There is no agreement because tors occur in many climates and rock types; different tors may have different origins.
Altiplanation (cryoplanation) terraces ⭐⭐
- Bench-like, flat surfaces cut into hillsides and summits in periglacial uplands, separated by steep scarps (risers, typically a few metres to about 10 m high).
- Formed by frost shattering at the base of a scarp, which makes it retreat, and solifluction, which carries debris across the flat tread. Described by H.M. Eakin (1916) in Alaska.
Nivation hollows ⭐
- Shallow hollows on hillsides under snow patches; can be transverse (across the slope), longitudinal (down the slope) or circular. They range from a few metres to over a kilometre across.