Quiz20

Geography notes

Notes · Geography

Mountain Building (Orogenesis)

Short, exam-focused revision notes. Read a section, then test yourself with a quiz.

4 min read8 sections8 chapters

Mountain Building (Orogenesis)

Meaning ⭐⭐

  • Mountains are second-order relief features of the earth (first order = continents and ocean basins; third order = small landforms made by exogenetic agents).
  • Mountains can occur in several forms (small → large):
Form
Meaning
Mountain ridge
A system of long, narrow, high hills. One slope is usually steep, the other gentler (sometimes both are symmetrical)
Mountain range
A linear belt of ridges, peaks, summits and valleys. All hills are of the same age, though their structure may differ
Mountain chain
Several parallel, long, narrow ranges of different ages, sometimes separated by plateaus
Mountain system
Ranges of the same age, separated by valleys
Mountain group
An unsystematic mix of different systems
Cordillera
A "community" of ridges, ranges, chains, systems and groups. Best example: the mountains of western North America
Memory tip: ridge → range → chain / system → group → cordillera (smallest to largest).

Classification of mountains ⭐⭐⭐

Mountains can be classified in four ways. The mode of origin and the age are the most important for exams.

1. By height ⭐

Type
Height
Low mountains
700–1,000 m
Rough mountains
1,000–1,500 m
Rugged mountains
1,500–2,000 m
High mountains
Above 2,000 m

2. By location ⭐

Type
Examples
Continental: coastal
Andes, Appalachians, Western and Eastern Ghats
Continental: inland
Himalaya, Rockies, Urals, Aravalli, Satpura, Kunlun, Tien Shan, Altai, Vosges, Black Forest
Oceanic
Mostly below sea level; most are volcanic
  • Mauna Kea (Hawaii) is only 4,207 m above sea level, but measured from the sea floor it is about 10,200 m, taller than Everest (8,849 m above sea level). ⭐
  • The mid-ocean ridge system (about 65,000 km) is the longest mountain chain on earth. ⭐

3. By mode of origin ⭐⭐⭐

Group
Type
Cause
Examples
Tectonic (original)
Fold
Compression: folding of crust
Himalaya, Alps, Rockies, Andes
Tectonic (original)
Block (horst)
Faulting by tensional (sometimes compressional) forces; linked to rift valleys
Vosges, Black Forest, Sierra Nevada, Satpura
Tectonic (original)
Dome
Magma intrusion and upwarping of the crust
Black Hills (USA), Henry Mountains (laccoliths)
Tectonic (original)
Accumulation (volcanic)
Piling up of lava, ash and cinders
Mt Fuji, Kilimanjaro, Mauna Loa
Relict / residual (circum-erosional)
Left standing when the surrounding land was eroded away
Denudation
Aravalli (worn-down old fold mountains), Vindhyachal, Eastern Ghats

4. By age (period of origin) ⭐⭐⭐

Orogeny
When
Examples
Pre-Cambrian
Oldest
Laurentian, Algoman and Killarnean mountains (N. America); mountains of Fenno-Scandia and NW Highlands of Scotland; Aravalli (India)
Caledonian
Silurian–Devonian
Scotland, Ireland, Scandinavia; northern Appalachians (Taconic); Brazilides of South America
Hercynian (Variscan)
Carboniferous–Permian
Vosges, Black Forest, Harz, Brittany, Cornwall, Iberian Meseta (Europe); Urals, Altai, Tien Shan (Asia); Appalachians (N. America)
Alpine
Tertiary
Rockies, Andes, Alps, Himalaya, Atlas, Carpathians, Pyrenees, Caucasus, Apennines, Zagros, Taurus
  • Order: Pre-Cambrian → Caledonian → Hercynian → Alpine (oldest → youngest).
  • Old fold mountains = before Tertiary (Caledonian, Hercynian). They are so worn down that they are called relict mountains. New fold mountains = Alpine (Tertiary).

Block mountains ⭐⭐⭐

  • Also called fault-block or horst mountains. They are the upstanding blocks between two faults, or on either side of a rift valley (graben).
  • Formed by faulting, caused by tensional and sometimes compressional forces from inside the earth. Related notes:
    Faults and Rift Valleys
    .

Two shapes ⭐

Type
Features
Tilted block
One steep side (a fault scarp) and one gentle slope. Example: Sierra Nevada
Lifted block (true horst)
Flat, tabular summit with very steep sides (two boundary fault scarps)

Three ways of formation ⭐⭐

  1. The middle block rises between two normal faults → horst; flat top, steep sides.
  1. The side blocks sink and the middle block stays → it stands out above the surroundings. Typical of high plateaus and broad domes.
  1. The middle block sinks (rift valley / graben) → the side blocks stand as horsts. Example: Vosges and Black Forest on either side of the Rhine rift valley.

Examples

Region
Block mountains
USA
Sierra Nevada (California; about 640 km long, 80 km wide, 2,400–3,600 m high; often called the most extensive block mountain), Wasatch Range (Utah), Basin and Range / Great Basin, Steens Mountain (Oregon)
Europe
Vosges and Black Forest (Rhine rift valley)
India
Satpura (a horst between the Narmada and Tapi rift valleys)

Theories of origin ⭐⭐

Theory
Idea
Status
Fault theory
Clarence King and G.K. Gilbert (1870–75) studied the Great Basin Range of Utah and called them faulted blocks. Louderback: faulting plus tilting. W.M. Davis also supported it
Accepted
Erosion theory
J.E. Spurr: the Great Basin ranges were not made by faulting but by differential erosion after their origin in the Mesozoic
Rejected: erosion can modify a mountain but cannot create one

Dome and volcanic mountains

  • Dome mountains: magma pushes up and arches (upwarps) the crust. Types: normal domes, lava domes, batholithic, laccolithic and salt domes.
  • Volcanic mountains (mountains of accumulation): built by lava, ash and cinders. Types: cinder cones, composite cones, acid lava cones, basic lava cones. Most oceanic mountains are volcanic. See
    Vulcanicity and Volcanoes
    .

Folded mountains ⭐⭐⭐

  • Formed by the folding of crustal rocks under compressive forces from inside the earth. See
    Folds and Nappes
    .
  • The highest and most extensive mountains in the world, found on all continents. Examples: Rockies, Andes, Alps, Himalaya, Atlas.

Classification ⭐⭐

Basis
Types
Nature of folds
Simple (open folds): wave-like anticlines and synclines. Complex: intensely compressed, recumbent folds forming nappes
Stage of erosion
Young (least denuded) and mature (monoclinal ridges and valleys). True young fold mountains are rare, because denudation starts as soon as uplift starts
Period of origin
Old (pre-Tertiary; Caledonian, Hercynian; e.g. Aravalli, Appalachians, Urals) and new (Alpine / Tertiary; e.g. Rockies, Andes, Alps, Himalaya)

Characteristics ⭐⭐⭐

  1. The youngest mountains on earth (most are Tertiary).
  1. Made of folded sedimentary rocks; they contain marine fossils, so the sediments were laid down in the sea.
  1. The sediments are very thick (over 12,000 m), yet the fossils belong to shallow-water animals. So the sea floor kept sinking as sediment piled up (sedimentation + subsidence).
  1. Long and narrow: the Himalaya is about 2,400 km long but only 150–400 km wide. They formed in long, narrow, shallow seas called geosynclines. "Geosynclines are the cradles of mountains."
  1. Often arc-shaped (one side concave, the other convex).
  1. Found along continental margins facing oceans: Rockies and Andes (west coasts, facing the Pacific); Alps (southern margin of Europe, facing the old Tethys / Mediterranean).
  1. Two trends: north–south (Rockies, Andes) and east–west (Alps, Himalaya).
  1. Zones of strong earthquakes and volcanoes today.
Memory tip: "SLAM": Sedimentary rocks, Long and narrow, Arc-shaped, Marine fossils.

Fold vs block vs dome vs volcanic ⭐⭐

ㅤ
Fold
Block
Dome
Volcanic
Force
Horizontal compression
Tension (sometimes compression) → faulting
Magma pushing up from below
Eruption and accumulation
Shape
Long, narrow, wavy ridges, often arcs
Flat top, steep fault-scarp sides
Rounded dome
Cone
Rocks
Folded sedimentary
Any rock, bounded by faults
Arched strata
Igneous (lava, ash)
Examples
Himalaya, Alps
Vosges, Sierra Nevada
Black Hills
Fuji, Kilimanjaro

Theories of mountain building ⭐⭐⭐

  • Block, dome and volcanic mountains are fairly well understood. The origin of fold mountains is the hard problem.
  • Many theories were proposed; none was accepted by everybody until plate tectonics (1960s).
  • Two groups: horizontal-force theories (contraction theories and drift theories) and vertical-force theories.
Theory
Scientist
Year
Group
Force
One-line idea
Geosynclinal orogen
Kober
1921
Contraction
Cooling and contraction of the earth
Two forelands squeeze a geosyncline into mountains
Thermal contraction
Jeffreys
1920s
Contraction
Cooling + slower rotation
A shrinking earth wrinkles; the "level of no strain"
Sliding continents
Daly
1926
Drift
Gravity
Continental blocks slide into geosynclines
Thermal convection currents
Holmes
1928–29
Drift
Convection currents from radioactive heat
Diverging currents open oceans; converging currents make mountains
Radioactivity (thermal cycle)
Joly
1925
Drift
Radioactive heat melting and re-solidifying the substratum
Sea transgression and regression squeeze margin sediments
Plate tectonics
Wilson, Hess, McKenzie, Morgan, Le Pichon
1960s
Drift
Plate collision (mantle convection)
Mountains form at convergent plate boundaries
Undulation / oscillation
Haarmann
1930
Vertical forces
Vertical movements
Not usually asked in detail
  • Common thread: the geosyncline idea runs through Kober, Daly, Holmes and Joly, and survives (in a new form) in plate tectonics. ⭐
  • Memory tip: Contraction = Kober and Jeffreys. Drift = Taylor, Wegener, Holmes, Daly, Joly, plates.

Sub-topics

Geosynclines
Geosynclinal Orogen Theory — Kober (1921)
Thermal Contraction Theory — Jeffreys
Sliding Continents Theory — Daly (1926)
Thermal Convection Current Theory — Holmes (1928–29)
Radioactivity (Thermal Cycle) Theory — Joly (1925)
Plate Tectonics and Mountain Building
Quick Revision — Mountain Building