Quiz20

Geography notes

Notes · Geography

Relief of the Ocean Basins

Short, exam-focused revision notes. Read a section, then test yourself with a quiz.

4 min read7 sections2 chapters

Relief of the Ocean Basins

Why it matters: Exams ask about the four relief zones of the ocean floor, the origin of continental shelves, the deepest trenches (Mariana first), submarine canyon theories, and the mid-oceanic ridges of the Atlantic, Pacific and Indian Oceans.

1. The hydrosphere at a glance

  • About three-fourths of the globe is covered by the hydrosphere. Total surface area of the globe is 509,950,000 km²; water covers 361,060,000 km² (71%) and land 148,890,000 km² (29%).
  • The hydrosphere is divided by size and location into oceans, inland seas, small enclosed seas and bays.
  • Areas of the three oceans: Pacific 165,000,000 km², Atlantic 82,000,000 km², Indian 73,000,000 km².
  • Like the lithosphere, the ocean floor has mountains (ridges), plains, basins, trenches and canyons.
  • Average depth of the oceans is 3,800 m, against an average land height of 840 m. The heights and depths are shown together on the hypsographic (hypsometric) curve.

2. The four relief zones ⭐⭐

Zone
Depth / slope
Share of ocean area
Continental shelf
Up to about 100 fathoms (about 180–200 m) deep (1 fathom = 6 ft); very gentle slope (often quoted as 1°–3°; actual average about 0.1°)
8.6% (Atlantic 13.3%, Pacific 5.7%, Indian 4.2%)
Continental slope
200–2,000 m deep; usually 2°–5°, locally much steeper (up to about 60°)
8.5% (Atlantic 12.4%, Pacific 7%, Indian 6.5%)
Deep sea plain
3,000–6,000 m deep; flat to rolling
75.9% (Pacific 80.3%, Indian 80.1%, Atlantic 54.9%)
Ocean deeps and trenches
The deepest depressions on the floor
Small, but the deepest parts

3. Continental shelves ⭐⭐

Definition: the marginal parts of the continents submerged under sea water, down to about 100 fathoms, sloping very gently towards the sea.

Width

  • Average width is about 48 km (Shepard took 67 km / 42 miles; modern estimates put it at about 80 km).
  • Width depends on the relief of the adjoining land:
    • Narrow where high mountains run close to and parallel with the coast. Example: the Pacific shelf off western South America is only 16 km wide because of the Andes.
    • Wide where the coast is a wide plain. Shelves are usually wider off river mouths, but the shelf off the Mississippi mouth is exceptionally narrow.
Size
Example
Narrow (16 km)
Pacific shelf of South America
Medium (96–120 km)
Atlantic shelf off the east coast of North America
Very wide (several hundred km)
East Indies, Arctic Sea, China Sea, Adriatic Sea, Arafura Sea

Origin of continental shelves ⭐

The nature, extent and depth of shelves vary so much that no single process explains all of them. Seven views are given:
#
View
Idea
1
Erosion + deposition
Waves and currents erode the continental margin into a platform; river and wave sediments then build it up and consolidate
2
Pure deposition
Rivers dump detritus in calm seas; the area subsides as sediment piles up. These are constructional and the most extensive shelves
3
Convection currents
Rising thermal currents converge at the continent–ocean boundary and descend; the compression makes the margin subside
4
Faulting
Parallel faults let the margin subside and submerge (tectonic shelves)
5
Glacial control theory (R.A. Daly) ⭐
Sea level fell in the Pleistocene Ice Age (Daly estimated 38 fathoms; modern estimates are about 120 m); exposed margins were glacially eroded into platforms and drowned again when ice melted
6
Wave-cut platforms
Waves cut cliffs that retreat landward, leaving platforms that later submerge
7
Tilting
Land tilting towards the sea submerges the margin and extends existing shelves

Continental shelves of India

  • The seaward limit is marked by the 100 fathom contour. The eastern shelf is about 50 km wide and the western shelf about 150 km wide.
  • The shelf is narrow (30–35 km) off the mouths of the Ganga, Mahanadi, Godavari, Krishna and Cauvery, and wider off the Narmada, Tapi and Mahi.
Part
Origin
Off the Ganga, Godavari, Krishna and Cauvery mouths
Delta formation
Midnapur to Madura (east coast)
Sedimentation and consequent subsidence
Andaman–Nicobar, Lakshadweep, Gulf of Mannar
Coral reefs
Western coast
Faulting and consequent submergence

4. Continental slope

  • The steep zone running from the shelf edge down to the deep sea plain.
  • The usual gradient is 2°–5°. Local extremes: about 40° near St Helena, 30° off Spain, 62° near St Paul, 5°–15° off Calicut.
  • Because of the steep gradient there is hardly any deposition; material is carried quickly downslope, though a thin veneer may remain.
  • The main features are submarine canyons and trenches, usually lying across the shelf and coast.
  • Origin: (1) erosion theory (based on submarine canyons, marine waves); (2) tectonic theory (faulting); (3) bending and warping of the shelf followed by sedimentation.

5. Deep sea plains ⭐

  • The most extensive relief zone (75.9% of the ocean area), flat or gently rolling, 3,000–6,000 m deep.
  • The Atlantic has the lowest share (54.9%) because of its larger shelves and marginal seas.
  • Mostly featureless, but with long narrow ridges and flat-topped sea mounts (guyots). Some ridges rise above the water as islands: the Mid-Atlantic Ridge, East Pacific Rise and Mid-Indian Ocean Ridge.
  • Covered by pelagic deposits (plant, animal and siliceous remains), with no terrigenous (land-derived) debris. A few places have volcanic deposits.

6. Ocean deeps and trenches ⭐⭐⭐

  • Deepest depressions on the ocean floor, usually parallel to coasts with young fold mountains and along island arcs.
  • Deeps = very deep but less extensive depressions. Trenches = long, narrow linear depressions. Both have very steep, sometimes almost vertical, sides.
  • Named after explorers (Murray Deep) or locations (Japan, Sunda trenches).
  • Of 57 surveyed deeps: Pacific 32, Atlantic 19, Indian 6.
  • Mariana Trench (deepest point: Challenger Deep), east of the Philippines near Guam in the North-west Pacific, is the deepest at about 11 km (about 10,935 m in recent surveys; older figures 11,022–11,034 m).
  • Origin: mainly tectonic activity linked to plate motions (plate tectonics).
Deep / Trench
Location
Depth (m)
Mariana (Challenger Deep)
North-west Pacific
About 10,935
Tonga
South Pacific
About 10,820
Kuril–Kamchatka
Off the Kuril Islands and Kamchatka
About 10,540
Philippine
East of the Philippines
About 10,540
Puerto Rico
North of Puerto Rico, Atlantic
About 8,380 (deepest in the Atlantic)
Romanche
Equatorial Atlantic
About 7,760
Java (Sunda)
East Indian Ocean
About 7,290 (deepest in the Indian Ocean)
Other Pacific trenches: Kermadec (about 10,050 m), Izu–Ogasawara (about 9,780 m), Japan (about 8,400 m), Peru–Chile (about 8,065 m), Aleutian (about 7,680 m), Ryukyu (about 7,460 m), Middle American (about 6,670 m). Most trenches are in the western Pacific.

Sub-topics

Submarine Canyons
Bottom Relief of the Atlantic, Pacific and Indian Oceans