6.1 Landforms and their development
Every landform has a history. It changes over time through the work of geomorphic agents, passing through stages similar to life: youth, maturity and old age.
6.2 Running water
In humid regions with heavy rainfall, running water is the most important geomorphic agent. It works in two ways:
- Overland flow on the general land surface, as a sheet. This causes sheet erosion.
- Linear flow as streams and rivers in valleys.
Overland flow concentrates into narrow paths called rills. Rills deepen and widen into gullies, and gullies grow into valleys.
Stages of river development
| Stage | Streams and valleys | Other features |
|---|---|---|
| Youth | Few streams, poorly integrated; V-shaped valleys, little or no floodplain | Waterfalls and rapids where hard rocks are exposed; broad, flat divides with marshes and swamps |
| Mature | Many streams, well integrated; deeper V-shaped valleys; trunk streams with wider floodplains; meanders develop | Swamps and marshes disappear; stream divides become sharp |
| Old age | Few small tributaries, gentle gradients; streams meander freely over vast floodplains | Natural levees, oxbow lakes, swamps; divides broad and flat; land close to sea level |
Erosional landforms of running water
| Landform | Description |
|---|---|
| Valleys: gorge | Deep valley with very steep to straight sides; width about the same at top and bottom. Forms in hard rocks |
| Valleys: canyon | Steep, step-like side slopes; wider at the top than the bottom. Forms in horizontally bedded sedimentary rocks. A canyon is a variant of a gorge |
| Potholes | Circular depressions in the rocky bed, drilled by pebbles swirling in eddies |
| Plunge pools | Large, deep potholes at the foot of waterfalls |
| Incised or entrenched meanders | Deep meandering gorges cut into hard rock, formed when the land was uplifted while the river kept cutting down |
| River terraces | Old valley-floor or floodplain levels left as steps on the valley sides. Paired terraces lie at the same height on both sides; unpaired ones do not |
Depositional landforms of running water
| Landform | Description |
|---|---|
| Alluvial fans | Form where a stream flows from high to low gradient at the foot of a slope and drops its coarse load in a fan. In humid areas fans are low cones with gentle slopes; in arid areas they are high cones with steep slopes |
| Deltas | Form where a river meets the sea or a lake. The load is sorted and layered: coarse material settles first, fine material is carried farther out |
| Floodplains | Formed by deposits on the riverbed and banks during floods. An active floodplain is the part flooded regularly; an inactive one lies above the banks |
| Natural levees | Low, linear ridges of coarse deposits along the banks, built during floods |
| Point bars | Deposits on the inner (convex) side of meander bends; also called meander bars |
| Meanders | Loop-like bends of a river channel; mainly from the river's tendency to swing laterally on gentle gradients. Erosion on the outer (concave) bank, deposition on the inner bank |
| Oxbow lakes | Cut-off meander loops |
| Braided channels | Where load is too heavy, the river splits into many channels around sand and gravel bars |
6.3 Groundwater (karst topography)
Groundwater acts as a geomorphic agent mainly in limestone and dolomite rocks, which dissolve in water containing carbon dioxide (carbonation). Any limestone or dolomitic region with typical landforms made by solution and deposition is called karst topography, after the Karst region of the Balkans next to the Adriatic Sea.
Erosional karst landforms
- Pools, sinkholes: small to medium funnel-shaped openings at the surface. Solution sinks form by dissolution; collapse sinks (dolines) form when a cave roof caves in.
- Uvalas (valley sinks): long, narrow troughs formed when several sinkholes merge.
- Lapies: irregular grooves and ridges on the surface; when the surface becomes a nearly flat rocky floor, it is a limestone pavement.
- Caves: formed by solution along joints and bedding planes, often with a stream flowing through.
Depositional karst landforms
- Stalactites: icicle-shaped deposits hanging from the cave ceiling.
- Stalagmites: deposits rising from the cave floor.
- Pillars (columns): where a stalactite and stalagmite join.
6.4 Glaciers
Masses of ice moving slowly as sheets over land (continental glaciers or ice sheets) or down valleys (mountain / valley glaciers) are glaciers. Glaciers erode strongly because of the friction and weight of the ice, and plucking of rock blocks from the bed.
Erosional landforms of glaciers
| Landform | Description |
|---|---|
| Cirque | Deep, long, wide armchair-shaped hollow at the head of a glacial valley. When the ice melts, a lake called a tarn may fill it |
| Horn | Sharp, pyramid-shaped peak formed by headward erosion of several cirques around a summit. Example: the Matterhorn (Alps); Everest is also a horn |
| Serrated ridge (arête) | Sharp, saw-toothed ridge between two cirques |
| Glacial valley (trough) | U-shaped valley with a broad floor and steep sides |
| Hanging valley | A tributary valley left hanging above the main glacial trough; often has a waterfall |
| Fjord | A very deep glacial trough filled with sea water, along coastlines (Norway, New Zealand) |
Depositional landforms of glaciers
Debris carried by glaciers is called glacial till when deposited directly by ice (unsorted mix of coarse and fine). Material deposited by meltwater streams is sorted and called glacio-fluvial or outwash deposits.
| Landform | Description |
|---|---|
| Moraines | Long ridges of till. Terminal moraine at the glacier's end; lateral moraines along the sides; medial moraine where two glaciers join; ground moraine under the glacier |
| Eskers | Long, sinuous (winding) ridges of sand and gravel deposited by meltwater streams flowing under the glacier |
| Outwash plains | Plains of sorted gravel, sand and silt built by meltwater at the glacier's front |
| Drumlins | Smooth, oval, egg-shaped hills of till. The blunt stoss end faces up-glacier; the tapered tail points the way the ice moved |
6.5 Waves and currents
Coastal processes are the most dynamic. Most of the work is done by breaking waves. The landforms depend on whether a coast is high and rocky or low and sedimentary.
High rocky coasts (mostly erosion)
- Sea cliffs: steep rock faces cut by waves.
- Wave-cut platforms (terraces): flat rock shelves at the cliff foot.
- Sea caves: hollows cut into the cliff.
- Sea arches: caves that break through a headland.
- Sea stacks: isolated rock pillars left when an arch roof collapses.
Low sedimentary coasts (mostly deposition)
- Beaches: sand or shingle (pebble) deposits; temporary, changing with the seasons.
- Dunes: sand ridges behind beaches, formed by wind.
- Bars and barriers: ridges of sand and shingle offshore, parallel to the coast. A barrier can enclose a lagoon.
- Spits: bars attached at one end to a headland or land.
6.6 Winds
Wind is a dominant agent in hot deserts. Deserts have large daily temperature ranges, sparse vegetation and loose material, so wind erodes freely. Rain is rare but comes as sudden downpours, so sheet floods also shape the land.
Wind erodes in three ways:
- Deflation: lifting and removing dust and fine particles.
- Abrasion: sand-blasting of rock surfaces by grains carried by the wind.
- Impact: the force of moving grains hitting rocks.
Erosional landforms of wind
| Landform | Description |
|---|---|
| Pediments | Gently inclined rocky floors at the foot of mountains, with or without a thin cover of debris |
| Pediplains | Low, featureless plains formed when pediments of a mountain region merge |
| Inselbergs | Isolated hills left standing on a pediplain; remnants of the old mountains |
| Playas | Flat basins in the middle of desert mountains, where water collects as a shallow lake after rain. When covered with salts they are called alkali flats |
| Deflation hollows | Shallow depressions formed by wind removing loose material |
| Mushroom, table and pedestal rocks | Rocks with a narrow base and wider top, because wind abrasion is strongest near the ground |
Depositional landforms: sand dunes
| Dune type | Shape and conditions |
|---|---|
| Barchan | Crescent-shaped; horns point away from the wind (downwind). Constant wind, moderate sand |
| Parabolic | Reversed barchan: horns point into the wind (upwind). Forms where sandy surfaces are partly covered by vegetation |
| Seif | Like a barchan with only one wing; forms when wind direction shifts |
| Longitudinal | Long ridges parallel to the wind; forms when sand supply is poor and wind is constant |
| Transverse | Ridges perpendicular (transverse) to the wind; forms when wind is constant and sand is plentiful |